Common Lifting Incidents & How to Prevent Them

Lifting operations remain one of the most hazardous activities on construction and industrial sites in Singapore. By studying past incidents, we can identify recurring patterns and implement targeted prevention measures.

Incident 1: Crane Topple Due to Overloading

What happened: A mobile crane attempted to lift a load at a radius beyond its rated capacity. The crane tipped over, killing the operator and a nearby worker.

Root causes:

  • Load weight was not accurately determined — estimated instead of weighed
  • Operator did not check the load chart for the actual operating radius
  • Load Moment Indicator (LMI) was disabled

Prevention: Always verify load weight. Never disable safety devices. Check the load chart for every lift — not just “similar” lifts you have done before.

Incident 2: Falling Load Due to Sling Failure

What happened: A webbing sling snapped while lifting a steel beam, dropping the load onto two workers below.

Root causes:

  • The sling had visible cuts from previous contact with sharp edges
  • No pre-use inspection was conducted
  • The sling’s WLL was insufficient for the load weight

Prevention: Inspect all slings before every use. Reject damaged slings immediately. Use edge protectors when lifting loads with sharp edges. Always match sling capacity to load weight.

Incident 3: Electrocution from Power Line Contact

What happened: A lorry crane boom contacted an overhead power line during unloading operations, electrocuting the rigger who was touching the load.

Root causes:

  • No survey of overhead hazards was conducted before the lift
  • No exclusion zone or spotter was designated for the power line
  • The lift plan did not identify the power line as a hazard

Prevention: Always survey the lift area for overhead power lines. Maintain safe clearance distances. Contact SP Group for cable identification and protection measures if working near power lines.

Incident 4: Worker Crushed by Swinging Load

What happened: A suspended load swung unexpectedly and pinned a worker against a wall.

Root causes:

  • No tag lines were used to control the load
  • The worker was inside the exclusion zone
  • The load’s centre of gravity was offset, causing it to swing when lifted

Prevention: Use tag lines on all loads to control swing. Enforce exclusion zones strictly. Identify the centre of gravity and rig accordingly — trial lift a few centimetres off the ground first.

Key Lessons Across All Incidents

  1. Plan every lift — even “routine” ones
  2. Inspect before use — every sling, every shift
  3. Enforce exclusion zones — no exceptions
  4. Never disable safety devices
  5. Verify load weight — never estimate
  6. Survey the lift area for overhead and underground hazards
  7. Use tag lines to control load swing
  8. Stop the lift if anything looks or feels wrong
Final Thought: Every lifting incident is preventable. The common thread in almost all lifting fatalities is a failure to follow established procedures. Plan the lift, follow the plan, and never take shortcuts.